Z stepper motor problem

[Clive S]

Hi Clive, thank you. I'm going to try to get the cable today as I want to get the cnc back up and running. Thanks for your help and will let you know how I get on. I will have to have a look at how I'm going to ground the screen at the control box end. Thanks again, Terry.

Strip back the sheaf and solder a wire to the screen about 150mm long folded back along the cable and heat shrink over it, then fix that wire to a common earth point.

[wrighty]

Thanks Clive, That's made things easier now I know what to do. Great advice mate, Thank you. Terry.

[wrighty]

Hi Guy's I just want to say thanks for your help. I'm all up and running again and all seems good at the moment. Fingers crossed lol. Thanks again guy's, really appreciate your help. Terry.

[Clive S]

Hi Guy's I just want to say thanks for your help. I'm all up and running again and all seems good at the moment. Fingers crossed lol. Thanks again guy's, really appreciate your help. Terry.

I take it you found the problem, It always helps others to divulge it.. Glad you got it working

[wrighty]

No Mate, I just replaced the cable and it's working fine. I assume it was a break in the cable somewhere. The connectors both ends looked fine. Terry.