1. #1
    Hi All
    Im having trouble with my puls settings on my 1325 dsp cnc router. the x and y are set to 120 and the z to 400 but its cutting too deep and i dont know the right settings that should be input. can anyone point me in the right direction?
    any help would be much appreciated.
    Many thanks in advance

  2. #2
    By moving it a set distance and measuring the actual movement you can calculate the required setting.
    You think that's too expensive? You're not a Model Engineer are you? :D

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Fanuc red cap pulse coder identification?
    By Ross77 in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 09-11-2018, 07:47 PM
  2. pulse generator for M542
    By gnalbant in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 03-07-2016, 10:50 AM
  3. pulse equivelant calculation
    By yasser in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 17-05-2016, 09:10 AM
  4. MPG or Hand Wheel Pulse Encoder where to buy in UK?
    By suesi34e in forum Marketplace Discussion
    Replies: 5
    Last Post: 02-01-2014, 03:41 PM
  5. Pulse rate or dip switch settings
    By Jopo in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 29-04-2013, 07:08 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •