Page 3 of 3 FirstFirst 123
  1. #21
    On your keyboard, the left and right arrows should jog the X axis up and down arrows for the Y and Page Up and Page Down for the Z.
    Provided you have the right pins settings in Mach3.

    One thing you may need to do with a parallel port card is check the port settings in Windows device manager and make sure that Mach3 has the same settings for the port.
    Mark Twain said that no amount of evidence will convince an idiot.!

  2. #22
    I did set them as such as that was how it was on the old computer, so I will check pin settings again. Many thanks.

Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. BUILD LOG: Made of aluminum, Made for aluminum: Would love design critique!
    By gamingan in forum DIY Router Build Logs
    Replies: 13
    Last Post: 27-06-2017, 10:33 AM
  2. Replies: 9
    Last Post: 16-11-2013, 03:27 PM
  3. How to get the balls back in a ballnut?
    By Shinobiwan in forum Lead Screws, Nuts & Supports
    Replies: 16
    Last Post: 24-03-2013, 03:35 PM
  4. Balls, balls and balls
    By Swarfing in forum Marketplace Discussion
    Replies: 15
    Last Post: 21-03-2013, 07:45 PM
  5. Lost my balls!!!
    By danielbriggs in forum Lead Screws, Nuts & Supports
    Replies: 26
    Last Post: 19-08-2010, 01:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •