Page 3 of 3 FirstFirst 123
  1. #21
    On your keyboard, the left and right arrows should jog the X axis up and down arrows for the Y and Page Up and Page Down for the Z.
    Provided you have the right pins settings in Mach3.

    One thing you may need to do with a parallel port card is check the port settings in Windows device manager and make sure that Mach3 has the same settings for the port.
    Albert Einstein may have been a genius, but his brother Frank, was a monster

    Having just moved to Windows 10 (which is crap) My stress levels are through the roof !!!

  2. #22
    I did set them as such as that was how it was on the old computer, so I will check pin settings again. Many thanks.

Page 3 of 3 FirstFirst 123

Similar Threads

  1. BUILD LOG: Made of aluminum, Made for aluminum: Would love design critique!
    By gamingan in forum DIY Router Build Logs
    Replies: 13
    Last Post: 27-06-2017, 10:33 AM
  2. Replies: 9
    Last Post: 16-11-2013, 03:27 PM
  3. How to get the balls back in a ballnut?
    By Shinobiwan in forum Lead Screws, Nuts & Supports
    Replies: 16
    Last Post: 24-03-2013, 03:35 PM
  4. Balls, balls and balls
    By Swarfing in forum Marketplace Discussion
    Replies: 15
    Last Post: 21-03-2013, 07:45 PM
  5. Lost my balls!!!
    By danielbriggs in forum Lead Screws, Nuts & Supports
    Replies: 26
    Last Post: 19-08-2010, 01:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •