. .

Thread: Design Spark

Page 2 of 2 FirstFirst 12
  1. #11
    Quote Originally Posted by cropwell View Post
    . . . . .
    I will re-address the issue of routing (pronounced rooting not rowting) tracks of a circuit to design a PCB which can then be isolation routed (this one you can pronounce rowting), when my frustration levels reduce to the point that my forehead is not in danger of demolishing a wall.
    . . . . . .
    One problem with British pronunciation down under is that routing (pronounced rooting not rowting) refers to act of copulation, as far as I have been able to ascertain between the giggles of others when I slip up!

  2. #12
    You could try KiCad. It does have Arduino Nano as a component. And it's free.

    I too found DesignSpark PCB utterly frustrating.
    Last edited by JohnHaine; 13-05-2019 at 09:59 AM.

  3. #13
    Quote Originally Posted by cropwell View Post
    Forking didn't work!
    A reasonable summary :-)
    Last edited by Doddy; 13-05-2019 at 12:29 PM.

  4. #14
    Quote Originally Posted by Doddy View Post
    A reasonable summary :-)
    'Forking' apparently is a way of taking somebodies project and copying it so that you can modify it. That was only one of the terms I was bombarded with that were new to me and not obvious what they sodding well meant.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Concept ultra precision CNC mill , Denford Novaturn and Concept spark eroder
    By mitip in forum Classified Ads, Buy, Sell & Swap
    Replies: 1
    Last Post: 27-11-2018, 09:01 PM
  2. Replies: 15
    Last Post: 25-06-2016, 10:13 PM
  3. Design Help Pt2 Required for CNC design/Build
    By MikeyC38 in forum Gantry/Router Machines & Building
    Replies: 38
    Last Post: 21-07-2014, 02:05 PM
  4. Review: Design Spark PCB software
    By Robin Hewitt in forum General Electronics
    Replies: 4
    Last Post: 29-05-2013, 10:54 PM
  5. Design help etc required with DIY CNC Router Design / Build
    By MikeyC38 in forum Gantry/Router Machines & Building
    Replies: 12
    Last Post: 21-10-2011, 04:50 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •