Threaded View
-
02-09-2019 #2
Bake your rods at 200 for 1 hour in the oven and then test one, they'll usually be fine.
You think that's too expensive? You're not a Model Engineer are you? :D
-
The Following User Says Thank You to magicniner For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
Schematic question wiring Am882 ALM Alarm, Limits and Security Relay Pilz S5 ?
By pierantoine in forum General ElectronicsReplies: 6Last Post: 01-05-2019, 02:32 PM -
Welding 5-8mm steel box-section tubes
By techcobweb in forum Welding, Brazing & EquipmentReplies: 9Last Post: 17-07-2018, 05:53 PM -
eBay Security & OpenSSL
By irving2008 in forum Marketplace DiscussionReplies: 10Last Post: 26-05-2014, 02:57 PM -
Maximum size of box section, Stacking box section, Construction Angle
By andy586 in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 01-02-2013, 05:29 PM -
Aluminium box section
By martin54 in forum Gantry/Router Machines & BuildingReplies: 11Last Post: 28-10-2012, 01:13 AM
Bookmarks