. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 14-09-2019 #1
    Palletlad's Avatar
    Lives in Swanley. Kent, United Kingdom.
    Palletlad
    Last Activity: 04-03-2024 Has been a member for 6-7 years. Has a total post count of 94. Received thanks 3 times, giving thanks to others 25 times.
    Hi all,
    I installed switches to my 6040 today (parallel running 2xX 2xY 2xZ) and cannot get mach3 to register them.

    I am using a UC400eth controller so no printer cable connection used and i have tested the physical side which all checks out correctly done. i set them as pin 11,12 and 13 for xyz home. any suggestions on what I'm missing?

    Almost forgot i set them up as open circuit.

    Kind Regards
    Last edited by Palletlad; 14-09-2019 at 10:47 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help please. Dip switches and mach 3 settings
    By Radu_Andrei in forum Motor Drivers & Controllers
    Replies: 261
    Last Post: 16-11-2019, 02:48 PM
  2. G540, homing switches and mach3
    By marbles in forum Artsoft Mach (3 & 4)
    Replies: 11
    Last Post: 02-06-2018, 02:55 PM
  3. Mach3 Setting up home and limit switches
    By CrazeUK in forum Gantry/Router Machines & Building
    Replies: 3
    Last Post: 03-02-2017, 01:18 PM
  4. Help withController dip switch settings and Mach3 motor tuning
    By liamo1991 in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 15-11-2013, 02:22 AM
  5. Limit switches and Mach3
    By cropwell in forum Artsoft Mach (3 & 4)
    Replies: 1
    Last Post: 06-03-2013, 10:51 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules