. .
  1. #1
    JimK's Avatar
    Lives in Cromer, Australia. Last Activity: 2 Weeks Ago Has been a member for 0-1 years. Has a total post count of 4.
    Hi All
    I have lost most of my settings for powering my cnc router which uses mach3. Now all works ok after re configuring but the limit switches do not work. I am using a JK02 breakout board and the inputs appear to be working because the diagnostics in mach3 show the correct activity when all the limit switches are activated. I have checked the settings in the "Ports and Pins" and they appear OK. Is there some other setting which could be incorrect? I have also checked the Estop settings and they appear to be working OK. Any suggestions?

    Regards JimK

  2. #2
    Jim, did you manage to get this sorted?
    .Me

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. switches settings in mach3
    By Palletlad in forum General Discussion
    Replies: 2
    Last Post: 3 Weeks Ago, 04:40 PM
  2. Mach3 and JK02-N breakout board
    By JimK in forum CNCdrive (UC100, UC300ETH)
    Replies: 4
    Last Post: 18-08-2019, 12:06 PM
  3. Mach3 Setting up home and limit switches
    By CrazeUK in forum Gantry/Router Machines & Building
    Replies: 3
    Last Post: 03-02-2017, 12:18 PM
  4. Limit switches and Mach3
    By cropwell in forum Artsoft Mach
    Replies: 1
    Last Post: 06-03-2013, 09:51 AM
  5. Replies: 2
    Last Post: 21-04-2010, 08:50 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •