. .

Thread: Time to share

Page 2 of 2 FirstFirst 12
  1. #11
    John, I think you misunderstood. I gave up on pourig unfilled epoxy to level uot linear rails supports.
    I would love to build my router entirely out of epoxy granite. Unfortunately getting aggregates in less than tonne per grade and lack of big enough flat surface to cast against pushed me towards steel.
    I'm still filling sections with epoxy granite but with aggregate far from optimal, mostly as dampening medium. Also hollow 100x50x4mm gets easily crushed when bolted together. Gantry beam is filled with epoxy granite to stop this. Gantry will be bolted with 4 m8 bolts at each side.

    Also if(and mostlikely will) my Z axis proves too flimsy to give reasonable aluminium cut finish it will get cast epoxy granite upgrade. But that's distant future.

    As for works update :
    Scraping done to within +0.05mm.
    Gantry beam is granited up
    Tomorrow hand scraper will get workout.
    Last edited by Sasquatch; 13-10-2019 at 05:37 PM.

  2. #12
    Update,
    Decided to order proper straight edge, HELIOS-PREISSER 0464103 Stahllineal DIN 874/0, 1000 mm. Straight and parallel to 0.012mm
    Came today, wrapped in cardboard with massive dent 200mm from end. Dropped it on granite surface plate -> 0.03 mm feeler gauge fits under, clearly bent.
    Sent it straight back(pun intended).
    Good in a way, laser+camera alignment works out much cheaper and as far as i can say just as accurate.
    Last edited by Sasquatch; 18-10-2019 at 08:41 PM.

  3. #13
    Z axis greasing extensions



Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Long time lurker, first time poster.
    By MatB in forum New Member Introductions
    Replies: 1
    Last Post: 18-02-2019, 05:49 PM
  2. Share some PCB design sites which may be helpful
    By Vicos in forum General Electronics
    Replies: 0
    Last Post: 22-08-2016, 08:10 AM
  3. NEW MEMBER: Hello - Keen To Share and Learn
    By dodo in forum New Member Introductions
    Replies: 5
    Last Post: 20-02-2013, 12:09 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •