. .
Page 2 of 2 FirstFirst 12
  1. #11
    Quote Originally Posted by johnsattuk View Post
    Complete control
    Yes John, I was thinking of doing something similar, I like the idea of having independent control of the fluid - and not having to buy an expensive pressurised contained for it!

  2. #12
    Not pressurized , can be placed almost anywhere, 25ltr drum on the floor if you like

  3. #13
    Quote Originally Posted by Voicecoil View Post
    Yes John, I was thinking of doing something similar, I like the idea of having independent control of the fluid - and not having to buy an expensive pressurised contained for it!
    just so you know this is what I am using in my system and as you can see its not expensive
    https://www.ebay.co.uk/itm/10-in-lin...EAAOSw~vNcBnGQ

    but I do like your complete system and if in had the time and ability I would build something like that

  4. #14
    That's a good idea - much cheaper than anything I've seen from pneumatics suppliers. Even so the independent pump approach is better for me as it means I can use a wee side channel blower I have here for the air. It only does 5psi, but when I tried it a few minutes ago it scattered chips over 2m from the pillar drill

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Ethanol mist for cutting aluminium
    By matt-b2 in forum Swarf & Chip Management
    Replies: 60
    Last Post: 15-08-2021, 11:05 AM
  2. Mist Coolant Project
    By magicniner in forum Swarf & Chip Management
    Replies: 10
    Last Post: 06-11-2018, 09:39 PM
  3. Schneider Altivar 320 wiring / setup help needed
    By TadasM in forum Spindles & Drive Motors
    Replies: 31
    Last Post: 21-10-2016, 07:43 AM
  4. WANTED: Mist lubrication system
    By badgerman in forum Items Wanted
    Replies: 9
    Last Post: 21-08-2014, 12:28 AM
  5. i7 Water cooling system
    By Jonathan in forum Metalwork Project Showcase
    Replies: 19
    Last Post: 01-01-2012, 06:27 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •