. .

Thread: Centre Drills

  1. #1
    Hi Everyone, Please share some advise.

    Which Centre Drills is good for spotting the location for the drilling operation?
    Last edited by jamesthomsan; 1 Week Ago at 11:05 AM.

  2. #2
    I think the answer's in the question! The best form of spotting drill is a spotting drill! Centre drills are intended for drilling holes in the end of a workpiece to take a lathe centre, hence the short projection to clear the point of the centre. Spotting drills are designed specifically for spotting, are much stiffer, less fragile (no delicate tip), and you can get them with angles to match the drills you are using. Plenty around on eBay, etc, or tool supplier of your choice.

  3. The Following User Says Thank You to Neale For This Useful Post:


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Startrite and Fobco Drills
    By Tenson in forum Workshop & Equipment
    Replies: 1
    Last Post: 19-07-2017, 12:37 PM
  2. Runout, HSS drills and dowel holes
    By hoezap in forum Metalwork Discussion
    Replies: 2
    Last Post: 08-03-2017, 12:36 PM
  3. Morse taper drills
    By John S in forum Marketplace Discussion
    Replies: 7
    Last Post: 08-05-2013, 07:00 PM
  4. FOR SALE: Mills, Thread Mill, Carbide Drills...
    By Jimmybristol in forum Items For Sale
    Replies: 1
    Last Post: 21-03-2011, 01:47 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •