. .
Page 2 of 2 FirstFirst 12
  1. #11
    Are all the axis free? no binding ?
    John S -

  2. #12
    jonm's Avatar
    Location unknown. Last Activity: 19-06-2011 Has been a member for 9-10 years. Has a total post count of 89.
    yes john everything seems free without the screws attached light finger pressure will move them

  3. #13
    It is the velocity and acceleration figures that adjust the speed, what are they set to?

  4. #14
    jonm's Avatar
    Location unknown. Last Activity: 19-06-2011 Has been a member for 9-10 years. Has a total post count of 89.
    Click image for larger version. 

Name:	mach3.bmp 
Views:	663 
Size:	3.75 MB 
ID:	1072hi
    i have tried various settings in here
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	mach3.jpg 
Views:	385 
Size:	63.1 KB 
ID:	1073  

  5. #15
    Right the maximum you can do with this is 177.18mm / min if it can get up to speed in time hence your 88mm/min or suchlike.

    Leave the steps alone and increase the velocity to 2,000 to start and acceleration to about 150 as a start point.

    .
    John S -

  6. #16
    jonm's Avatar
    Location unknown. Last Activity: 19-06-2011 Has been a member for 9-10 years. Has a total post count of 89.
    thanks john
    so my steps are set right , will try the settings you suggest, i knew i should be able to get a bit more speed somehow, if i can even get to 1000mm a min i will be happy

  7. #17
    jonm's Avatar
    Location unknown. Last Activity: 19-06-2011 Has been a member for 9-10 years. Has a total post count of 89.
    managed to get my speed up , wired the steppers bipolar single coil
    at 2.5 amps the 3nm motors are down to about 2nm but the speed has increased quite considerably can get about over 1000mm/min

  8. #18
    If you increase speed, then the torque will inevitably go down.

    What was the problem?

    (Glad you got it sorted!)

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need to slow down a signal due to Safe Torque Off alarm
    By corkcnc in forum General Electronics
    Replies: 0
    Last Post: 04-06-2014, 11:35 PM
  2. Machine Slow on Curves
    By swisscheese in forum Computer Software
    Replies: 31
    Last Post: 12-04-2014, 12:49 AM
  3. HSM Advisor - High Speed Machining feed & speed calculator
    By magicniner in forum CAD & CAM Software
    Replies: 2
    Last Post: 20-01-2014, 12:57 PM
  4. Help! Steppers losing steps and making a racket under slow feed..
    By fasteddy in forum Stepper & Servo Motors
    Replies: 23
    Last Post: 06-08-2011, 03:03 PM
  5. Forum Slow
    By pcstru in forum General Discussion
    Replies: 3
    Last Post: 27-01-2011, 03:54 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •