Thread: Help with CNC 3018 from Banggood
Threaded View
-
13-03-2020 #1
Good afternoon,
I need help in trying to run my 3018 CNC purchase on Banggood.
I installed 5 micro switches (2 X, 2 Y and 1 Z) to act as end stops and used for homing.
The homing cycle works fine. I home and zero my machine in the lower left corner of the table, however, when I want to carve, using Easel, it gives me a hard limit alarm as soon as I try to turn on the spindle.
After hours of reading, I changed all my limit switch wiring to shielded wires……..Nothing still same issues.
After homing,
• my machine positions are X = -284, Y = -2, Z = -2
• my work position is X = 0, Y = 0, Z= 0
If, after homing, I remove the limit switches using $21=0 and try to start a carve, my spindle will start but then, my table moves (Y axis) moves a few mm into the back frame (I have a 2 mm homing pull-off). It should move towards the front?????
Please help, thank you.
Jean
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
3018 Pro has no connectivity on A5 pins.
By deepcut66 in forum Chinese MachinesReplies: 0Last Post: 29-02-2020, 10:48 AM -
3018 3 Axis Mini DIY CNC Router ONLY Ł125 with free shipping !!!
By Lee Roberts in forum Marketplace DiscussionReplies: 6Last Post: 09-01-2020, 09:00 PM -
3018 problem
By bazbalz in forum Machine DiscussionReplies: 8Last Post: 17-12-2019, 12:58 PM
Bookmarks