New to CNC and feel like on deep water

[TonyGR]

Hello all and thank you taking me as your member.
I am from Athens Greece and after all the lathes and 3d printers decided to start on CNC also.
Took from a friend a Biemmepi FP53 https://www.biemmepi.it/downloads/ca...P_23_53_64.pdf that was functional but i knew there was a problem with one of the drivers, so i am deciding to take the Mach3 route with some DM556D driver and a control board but i have no clue how and where to start.
Any comments or ideas will be appreciated.

[Doddy]

Looks like an interestingly built small form factor router - likely a little limited in what it can cut but a useful intro to CNC. I'd definitely strip down and test everything to understand how much can be re-used and you could save a lot of money that way. If you grab some photos of the boards and drivers you'll likely get some good advice from here.

[TonyGR]

So far has been there and done that. seems to have all other components functional, besides electronics. I will post later in the day pictures from many of the components, good thing is that my friend used to cut up to steel with this thing.