Thread: Rookie needs advice.
Threaded View
-
24-10-2009 #2
Hi and welcome...
The WMD25V table wise is very similar to other mills of the RF25/RF30/Warco/Chester etc persuasion and there are several here that have been converted - look for threads by Robin Hewitt and Bill Todd by way of example. The vertical axis on these is a lot simpler than the round column versions however you still have the choice of motorising either the head movement or the quill... most opt for the quill so in that case there is much similarity as compared to CNC'ing the round column units.
I am not aware of any books that cover this specific subject, but have a look at the threads on here and also on CNCZone. There is a site here thats details a conversion of an RF45 clone, the bigger version I think of yours.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Looking for some CAM advice
By m_c in forum DolphinReplies: 4Last Post: 15-12-2013, 10:17 PM
Bookmarks