. .
Page 2 of 2 FirstFirst 12
  1. #11
    So you are electronic gearing at 10:1 (10,000/(10/1)=1000ppr
    -use common sense, if you lack it, there is no software to help that.

  2. #12
    Doddy's Avatar
    Lives in Preston, United Kingdom. Last Activity: 4 Hours Ago Has been a member for 6-7 years. Has a total post count of 798. Received thanks 128 times, giving thanks to others 34 times. Referred 1 members to the community.
    Yes, though within UCCNC I've settled at 1500ppr, which accounts for the 40:60 pulleys.

  3. #13
    Doddy's Avatar
    Lives in Preston, United Kingdom. Last Activity: 4 Hours Ago Has been a member for 6-7 years. Has a total post count of 798. Received thanks 128 times, giving thanks to others 34 times. Referred 1 members to the community.
    ...which was to recover the 2000rpm spindle speed on a 3000rpm servo that replaced a 5000rpm BLDC. My head hurts.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Options for replacement lathe spindle motor
    By Doddy in forum Spindles & Drive Motors
    Replies: 2
    Last Post: 09-11-2019, 10:53 AM
  2. lathe dc servo motor brake/spindle lock ??
    By dazza in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 0
    Last Post: 01-11-2014, 04:22 PM
  3. Replies: 2
    Last Post: 23-04-2014, 02:14 PM
  4. 2.2kw servo motor for spindle
    By blayde in forum Spindles & Drive Motors
    Replies: 1
    Last Post: 01-01-2014, 03:48 AM
  5. servo motor as spindle motor
    By Scott in forum General Discussion
    Replies: 1
    Last Post: 03-10-2010, 05:42 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •