Down Sizing to 5 axis.

[Evengravy]

Coming together quickly. Any hint to how you'll put the 5th axis together? Or maybe that would spoil it...:)

[Mister Mills]

Hey John, I can't really give you any update on the 5 axis just yet. I need to get the xyz up and running first off to machine the bits I need. It will be table based ( 2 rotational axis) as opposed to rotating the z axis and a rotary table. I have finally got a notification that my motors are in transit and all going well I should have them next week at some stage. Fingers crossed. The atc will arrive early next month. :(. Still a ton of stuff to do before then. How is the base coming along for your setup?

[Evengravy]

Ah right. Well you're getting stuff done much quicker than I did that's for sure.