Converion based upon my old Deckel Mill

[Kitwn]

This forum entry refers to the problem and sugests a solution.

https://cambamcnc.com/forum/index.ph...sg6459#msg6459

To change the post-processor click on the 'system' tab, and select the correct post-processor from the list in there. If this doesn't work then try a search on the CamBam forum. Copy and paste the error message into the search box. There are plenty of results to choose from!

[JAZZCNC]

So when I click start , the process begins and looks promising until it stops and I get I get an error message .
Says "Radius to end of arc differs from Radius to start (with block reference )
Block is G2 F800.0 X180.0 Z-0.0856 I-12.5717 J58.6681
No radius in there to trouble us , is there ????

Go into mach3 general config and change the I/J settings that should get rid of the message.

[John11668]

This forum entry refers to the problem and sugests a solution.

https://cambamcnc.com/forum/index.ph...sg6459#msg6459

To change the post-processor click on the 'system' tab, and select the correct post-processor from the list in there. If this doesn't work then try a search on the CamBam forum. Copy and paste the error message into the search box. There are plenty of results to choose from!

Been to the forum and this does seem to be a common problem, but there are hundreds of similar blocks in the code so editing isnt going to be the answer.
Have tried changing the PP to Mach 3 but the indicator ( green arrow )stays at default . Does this only work on licensed version perhaps ?

[John11668]

Go into mach3 general config and change the I/J settings that should get rid of the message.

Will look at that Jazz but immediate question is What do I change them to? Remember I am a raw newbie

[John11668]

Got it !
Config/ general config/ then change IJ mode from absolute to incremental and that seems to have done the trick
Starting to make some progress now . (I hope )
Thanks Guys.

[JAZZCNC]

Got it !
Config/ general config/ then change IJ mode from absolute to incremental and that seems to have done the trick
Starting to make some progress now . (I hope )
Thanks Guys.

Yep, that's the one.