-
27-05-2020 #1
Hi all
I am working for a small hydraulic engineering company, we have recently bought a CNC mill to manufacture some of our equipment in house.
I am also trying to set up some metrology equipment.
Can anyone please tell me how to directly message a member as I can see they probably have the information that I would like.
Thanks
-
28-05-2020 #2
Giff,
I think you have to make a minimum of ten posts before you can access some functions of the forum including adding pictures and probably sending PMs.
KitAn optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
-
The Following User Says Thank You to Kitwn For This Useful Post:
-
28-05-2020 #3
-
The Following User Says Thank You to Clive S For This Useful Post:
-
28-05-2020 #4
post a few more times even if its just saying hello a few times
-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
-
28-05-2020 #5
Thanks everyone, I didn't expect such a fast response and from several people.
-
28-05-2020 #6
If you think that was fast, just try posting that you have bought a pile of electroinics, and motors and you're about to design a CNC router around it!
-
28-05-2020 #7
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
eazicnc 3 'SAFETY' message
By makman in forum General DiscussionReplies: 5Last Post: 28-01-2019, 09:14 AM -
Message for member SMASH
By birchy in forum General DiscussionReplies: 1Last Post: 07-08-2013, 09:40 AM -
send pictures via PM
By dazza in forum General DiscussionReplies: 1Last Post: 27-06-2013, 10:10 PM -
Add Operator Message in G-code?
By Tenson in forum Programmers CornerReplies: 6Last Post: 07-02-2013, 07:39 PM -
How do i send a PM?
By Jonathan in forum General DiscussionReplies: 6Last Post: 03-09-2012, 10:42 PM
Bookmarks