. .
  1. #1
    Hi all, Im relatively new to CNC so I could be making an obvious mistake here!
    I have a Fanuc controlled Harrison 330 Alpha lathe, its a great machine being very versitile but Im having trouble with setting the Z workshift in full CNC mode. There is no G54 active on this machine.
    To set the workshift I call up the first tool T0101 in mdi and the set the position I want Z 0 with that tool, I then go to workshift and input Z0, when I then command T0101 Z 0 in mdi the postion of the tool goes to Z -33.295 which happens to be the offset of tool 1, consequently if I then repeat the process of setting the workshift as before it works fine and goes to the correct tool 1 Z 0 position!, and will from there on unless the computer is restarted! Obviously this will cause a crash if I run a program. I could/ very likely be doing something wrong procedurely or possibility setting tooloffsets incorrectly. Id post some pictures of the screen but not sure how to.
    Any guidance appreciated on what the problem might be.
    Last edited by Sucram; 18-06-2020 at 11:53 AM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Harrison Alpha 330 lathe Fanuc 21it SRAM back up problems
    By Sucram in forum General Discussion
    Replies: 14
    Last Post: 24-02-2021, 03:44 PM
  2. Replies: 0
    Last Post: 15-12-2019, 09:44 PM
  3. keyboard interface problem (Denford lathe)
    By asto in forum Denford Lathes
    Replies: 0
    Last Post: 29-07-2015, 06:38 PM
  4. FANUC 10TF Profiling problem
    By macca5 in forum Programmers Corner
    Replies: 1
    Last Post: 06-12-2011, 12:47 PM
  5. got a problem cant find belts for lathe
    By Scott in forum Machine Discussion
    Replies: 4
    Last Post: 08-09-2010, 01:35 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •