. .

Thread: Cambam forum

Page 1 of 2 12 LastLast
  1. #1
    Hi folks
    A bit of an appeal here .
    I am trying to register on the Cambam forum and all seems to go smoothly to the point where I am told to await the email to confirm .
    The email never comes .
    I have checked that I put the correct email address. Even re registered with different username and Email. Still nothing.
    I cant see a way to contact Admin on that forum while my registration is not complete .

    If anyone is already on that forum can you please report this to Admins . I am sure they dont want to miss out on genuine candidates

    Thanks

  2. #2
    It hasn't gone in your spam folder has it?

  3. #3
    will check again but I dont think so

  4. #4
    Nothing in Junkmail folder either

  5. #5
    I've logged in and had a look around the forum but there doesn't seem to be any news of problems. Are you still waiting?

    Kit
    An optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.

  6. #6
    Hi Kit
    Thanks for your concern.
    There was some stuff on the open part of the forum about the new site and initial problems with spammers.
    Maybe I have been shut out by the countermeasures . Three days now with no response.
    Do you have a contact email for their admins

  7. #7
    I don't have any contact details but have asked for asistance on your behalf with a link to this thread.

    Kit
    An optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.

  8. #8
    Many thanks Kit
    Will look out for some contact
    John

  9. #9
    An optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.

  10. #10
    Thanks Kit
    Will see what now transpires

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Trying to fathom cambam
    By John11668 in forum General Discussion
    Replies: 6
    Last Post: 09-07-2020, 09:09 PM
  2. Cambam with Mach3
    By ladybreaker in forum General Discussion
    Replies: 13
    Last Post: 26-02-2017, 05:56 PM
  3. Mach3 / cambam
    By dudz in forum Artsoft Mach (3 & 4)
    Replies: 5
    Last Post: 01-04-2013, 06:02 PM
  4. Cambam / milling Alu
    By dudz in forum CAD & CAM Software
    Replies: 5
    Last Post: 23-12-2012, 05:22 PM
  5. How do i make this in cambam?
    By motoxy in forum CAD & CAM Software
    Replies: 4
    Last Post: 09-02-2012, 06:01 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •