Hello everyone,
I've finally been able to spend some time and get power to the machine.

All seems to power up ok, screen on, inverter ready etc.

Currently 'drives on' will not execute.
I've done a keyboard test and it's the only button that does not register, however, when opened up and pressed my continuity tester beeps so I think the fault lies further down line.

It's showing an Axes xyz drive Fault.

Obviously this was cheap for a reason!!!

I do have the manuals and electrical schematic for the machine... stupidly I left them 30miles away at home...

Anyway enough for today, I've posted up the inner workings pics if anyone is interested in viewing.

My aim is at the very least to use this as a base even if it requires all new electronics motors etc...

I'm great on the software side... Unfortunately not so good on the hardware... Any help/comments/advice welcome

Rs232 cable connector I'll have to dig out an old pc!!

Sent from my Mi A1 using Tapatalk