Thread: Hi All

  1. #1
    Hi all,

    I'm a newbe on this community.

    I have a 12year+ old Step4 router, not brilliant but ok for balsa, ply without knots. Fitted a cheepo 240v router, will cut any ply, plastics now. The weight and offset of the spindle from the yaxis guides makes it abit wobbley. It's in semi retirement at the moment, shall make new spindle using air grinder innerds driven by a belted Brushless 400w motor and set guides one above the other.

    2 weeks ago I got an X1 mill from Arc-Euro with lecy bits up and running so now I can make parts for Step4.

    Software is:-

    DoubleCad XT free! only 2D but a good cheap start.

    Cut2d - Wonderfully straight forwards. One weekend I tried 3 different CAM sample programs, the next Thurs I used them again and found Cut2D was the only one I could use without cursing.

    Mach 3 - Another good Prog.

    Last edited by ChrisG; 06-11-2009 at 04:14 PM.

  2. Welcome Chris... I moved your intro into a new thread of your own rather than hijacking Airwolfs!

  3. #3
    Thanks Irvin,

    I'm not too bright at times,


  4. #4


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts