. .
  1. #1
    My first attempt at cutting oak. Just a little something for my girlfriend from a few offcuts of oak, I must say it cuts really well. The box was modelled using vcarve and I created a 3d printed jig for holding the heart lid while profiling the top.



    Sent from my M2003J15SC using Tapatalk

  2. The Following User Says Thank You to CharlieRam For This Useful Post:


  3. #2
    Nice work Charlie.

    But whatever you don't put a ring in that box and get down on one knee otherwise it will be the last Oak you cut..
    -use common sense, if you lack it, there is no software to help that.

    Email: dean@jazzcnc.co.uk

    Web site: www.jazzcnc.co.uk

  4. #3
    Cheers Jazz, there's no danger of that happening....I learned the hard way

    Sent from my M2003J15SC using Tapatalk

  5. #4
    Holy Cow!
    That's an amazing piece :0
    I love this project showcase section only because of this beautiful and innovative work. Keep going :)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 5
    Last Post: 15-04-2012, 11:36 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •