-
18-03-2021 #11
So bear with me on this or maybe the I-phone users will point me to an easy way. My new Android also saves pics in HEIC so that windows cant manage them.
It does however put them into google photos so i can download them . I then use an online converter for jpeg, so lets see if it works.
2 pics .
First shows my adaptor for tool block fitted to slide using existing tapped holes, and my initial attempts at a "rear" parting off toolpost .
Second shows improved PO toolpost, with T37 tool block above . I am using a narrow tip tool for the sort of profiling which is generated by Mach Wizards .
Have to say that Mach 3 wizards have some very inefficient routines , but like the old bike , good enough to learn on.
Parting off on TCL with 20mm bar struggles a bit so will be looking to see if my DC controller can boost a bit
-
18-03-2021 #12
Seemed to work , but if I click the pics they get turned 90 degrees , so you may have to lie down for a good look
Are you using the original motor and lenze controller Will?
-
18-03-2021 #13
My TCL125 has a factory fitted Dickson QCTP of the same size as is sold for the Myford Super7 and ML7.
You think that's too expensive? You're not a Model Engineer are you? :D
-
18-03-2021 #14
Mine are aftermarket copies but the same size and reasonable enough for me . The genuine article would probably have cost me more than the machine did.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
eBay: Denford / orac topslide and quick release tool post holder and holders
By ccw in forum Items On eBay UKReplies: 0Last Post: 15-08-2017, 04:13 PM -
Boxford TCL 160 tool alignment
By Saracen in forum Boxford LathesReplies: 2Last Post: 05-11-2014, 10:28 PM -
WANTED: Boxford design tool Software V10
By weeden007 in forum Items WantedReplies: 2Last Post: 15-02-2013, 04:24 PM -
7 x 12 tool post modification
By fragger6662000 in forum Milling Machines, Builds & ConversionsReplies: 1Last Post: 25-09-2011, 10:02 PM -
WANTED: Boxford 125TCL Tool holder?
By Minnican in forum Items WantedReplies: 2Last Post: 16-02-2011, 09:22 PM
Bookmarks