Denford easimill help

**JMH** · 07-02-2022

Hello Colin,
the spindle bearings, can you let us know the numbers?
TIA,
H.

**Colin Barron** · 12-02-2022

Originally Posted by JMH

Hello Colin,
the spindle bearings, can you let us know the numbers?
TIA,
H.

Hi,
Have a look on the Denford forum for the manual which is well worth downloading,

Regards
Colin

**JMH** · 12-02-2022

Hello Colin yes I have done, the page is no longer there ! I have the TIP manual, but the bearing arrangements are dfferent.
John.

**Colin Barron** · 14-02-2022

Originally Posted by JMH

Hello Colin yes I have done, the page is no longer there ! I have the TIP manual, but the bearing arrangements are dfferent.
John.

Hi,
i only have an Easiturn 3 drawings. Imperial bearings were still available for the lathe, the best price was from George Lodge bearings. They are more expensive than metric bearings. Actually the old bearings looked ok but for £81 i changed them anyway.

A tip when removing motor pulleys, on one, i think it was the spindle motor, the grub screw locking on the key was actually 2 grub screws.