. .
Page 3 of 3 FirstFirst 123
  1. #21
    Good news and Bad news............
    Good, I have the mill under control from mach3 via the UC400ETH
    I had to fiddle around a bit, the CNCDrive manual didn't work perfectly for me.
    Bad, I've discovered I hadn't kept a backup of my mach3 machine profile somewhere other than on the computer that I used to control it (and which died a sudden death)
    So I am plodding through ALL the settings, including faffing with the acceleration etc.
    I'm sure everyone else is much more organised than me, but if you haven't got your profile saved somewhere else, I really recommend you do it asap!

  2. #22
    Quote Originally Posted by ian823478 View Post
    Good news and Bad news............
    Good, I have the mill under control from mach3 via the UC400ETH
    I had to fiddle around a bit, the CNCDrive manual didn't work perfectly for me.
    Bad, I've discovered I hadn't kept a backup of my mach3 machine profile somewhere other than on the computer that I used to control it (and which died a sudden death)
    So I am plodding through ALL the settings, including faffing with the acceleration etc.
    I'm sure everyone else is much more organised than me, but if you haven't got your profile saved somewhere else, I really recommend you do it asap!
    Good tip.

    Did you have any import charges to pay when you got the goods from CNCDrive?.
    I've just got my quote back for a 'couple' of bits.

Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for parallel port cable
    By eurikain in forum Computer Hardware
    Replies: 3
    Last Post: 20-02-2016, 01:51 AM
  2. Grounding help, UCCNC, UC300 and connection loss
    By gabi68 in forum CNCdrive (UC100, UC300ETH)
    Replies: 6
    Last Post: 14-10-2015, 07:42 PM
  3. parallel port address
    By Dan Brown in forum Artsoft Mach (3 & 4)
    Replies: 6
    Last Post: 07-01-2010, 12:04 PM
  4. Laptop, ie no parallel port?
    By tompsky in forum Laptops & Tablets
    Replies: 3
    Last Post: 11-11-2008, 07:12 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •