Lighburn NEJE 30w laser not ramping up power

[Fivetide]

Its working .. as in the laser comes on at very low power and creates a spot. But if I use test software in light-burn that ramps its from 10% to %100 its get brighter but wont even draw a line on paper - it goes through the file doing the same thing. Not sure what is wrong. If I press the fire button on the laser motherboard it instantly burns a hole in the paper.

[Fivetide]

videos of problem added

focus test

onboard full power button burn

Off to get a new Arduino from CPC see if its the cheap clone problem

[Doddy]

I know nothing of the hardware, nor software. But, ultimately this will be a TTL-level signal between whatever controller and the laser. Gut feeling is you've got a PWM output on the ardi that is either "wrong" (maybe duty cycle?, or some internal calibration), or the software is mis-configured. If you've got access to a scope I'm be examining the signal to the laser and taking it from there. If you get stuck - I'm local, can offer a second pair of eyes and a scope.

[Fivetide]

I've swapped out the Arduino still same result.
I've red that if the feed rates are to low it will not power up because it will burn. But I think its a faulty laser motherboard. I've seen these working on much lesser machines on youtube. I've sent the video to the maker.. see what they say.
But I might bypass diodes and fit a C02 to it.