. .

Thread: newbe

  1. #1
    HI all new to this trying out as a hobby as been doing some woodwork for a number of years so thought i build my own rather than spending a fortune on a pre built one have purchased and built it wired it according to the old internet but cant seem to figure out how to get it going it is made up of 3 nema 23 along with 3 tb6600 and a break out board first question what should the dip pins be set to second installed mach3 software but cant get motors to work even though lights are on the 3 driver boards and breakout board flashing any help
    kevin

  2. #2
    managed to fix out re installed softwear also found out pin 1 and 6 an tb6600

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Total Newbe to CNC
    By tommyb43 in forum New Member Introductions
    Replies: 0
    Last Post: 29-12-2016, 09:53 PM
  2. NEW MEMBER: Newbe on the site
    By Phillou in forum New Member Introductions
    Replies: 0
    Last Post: 14-03-2014, 05:54 PM
  3. NEW MEMBER: Newbe
    By THE PHOENIX in forum New Member Introductions
    Replies: 2
    Last Post: 03-12-2010, 07:20 PM
  4. NEW MEMBER: Hi from newbe
    By croy in forum New Member Introductions
    Replies: 2
    Last Post: 28-01-2010, 09:22 PM
  5. NEW MEMBER: Newbe
    By cncezee in forum New Member Introductions
    Replies: 3
    Last Post: 29-08-2009, 07:40 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •