Threaded View
-
18-01-2022 #15
Must admit that I was confused about the device and PC addresses at first when I fitted my UC300ETH. I set the addresses the wrong way round as well. And that's after a working life in IT and a lot in IP networking! I think that the manual is a little bit ambiguous and as long as you read it the right way - or have done it once and see what they mean! - it's OK. Anyway, good that it's working, and don't feel bad about getting it wrong. Now, where's the red face icon when you need it?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help needed to connect my VFD to the AXBB controller
By CharlieRam in forum Spindles & Drive MotorsReplies: 24Last Post: 23-09-2020, 12:10 PM -
correct wiring sizes for JMC Servo iHSV57-30-18-36-21 with axbb-e controller
By the great waldo in forum General ElectronicsReplies: 18Last Post: 31-01-2020, 11:58 PM -
Any USB/Ethernet controller suggestions?
By jtar40 in forum Motor Drivers & ControllersReplies: 64Last Post: 15-05-2019, 07:58 PM -
USB/Ethernet controller for Mach3/4 advice
By paulus.v in forum Control Hardware & SystemsReplies: 17Last Post: 17-02-2015, 09:37 PM -
CNC controller with serial (RS232) communication
By rnr107 in forum Motor Drivers & ControllersReplies: 15Last Post: 28-02-2012, 09:49 PM
Bookmarks