. .
  1. #1
    Hello i was hoping someone could me. I have a 2012 pratix s15 router and when i turned on thursday morning last the handcontroller would not connect to the kvara plc in the machine. The error is E100d. its a esa s500 rack cnc post processer. could it be a plc card issue im at a loss. Any ideas would be greatly appreciated. Thanks

  2. #2
    Hi Kenny,

    Sorry to be the bearer of bad news but you are not going to get much help around here because very few have experience with machines like the SCM and even if they did I suspect you'll find they couldn't help because they wouldn't know the PLC ladder. This is something you would probably only get from SCM directly or an SCM engineer and in my experience, they don't give info like this away for free.

    Good luck
    -use common sense, if you lack it, there is no software to help that.

    Email: dean@jazzcnc.co.uk

    Web site: www.jazzcnc.co.uk

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. G-code Error ?
    By cpf in forum General Discussion
    Replies: 5
    Last Post: 12-01-2021, 10:56 AM
  2. Xsy-at1 error 6 over current
    By greg_brister in forum General Electronics
    Replies: 9
    Last Post: 20-02-2020, 09:09 PM
  3. Yasnac LX3 310 Error
    By fvfdrums in forum Machine Control Software
    Replies: 2
    Last Post: 30-04-2019, 06:11 PM
  4. VFD error
    By routercnc in forum Spindles & Drive Motors
    Replies: 37
    Last Post: 21-06-2014, 07:40 PM
  5. Solidcam error
    By Kai in forum Solidworks
    Replies: 5
    Last Post: 10-05-2011, 02:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •