I just picked up a Cadet Plus which I hope to get working again using a XC906t controller, a couple of modern stepper drivers and the origional motor/speed controller. I have not looked at the spped controller yet but I will probably use a PWM to 10V interface to provide optical isolation between the low and high voltage circuits.

The electrics/electronics side of things do not bother me but this is my first lathe and there are lots of very simple (dopey) things I still have to learning about.

To help me on my way I was wondering if anyone had a scanned copy of the original Cadet Plus "hardware/technical" manual?

I know the unit was based on an ML10 but I was hoping the original conect manual would cover maintenance, technical specifications, accessories, spare parts list etc.