. .
  1. #1
    Is there any easy cheap way to tram the nod on a workbee other than paying over 100 for a gauge

  2. #2
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom. Last Activity: 19 Hours Ago Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,434. Received thanks 1,445 times, giving thanks to others 108 times. Referred 1 members to the community.
    Just use the widest cutter you have and write a bit of code to make test cuts for both directions on a piece of scrap then adjust as required, doesn't take very long and no gauges are required.
    -use common sense, if you lack it, there is no software to help that.

    Email: dean@jazzcnc.co.uk

    Web site: www.jazzcnc.co.uk

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Ozznest workbee wanted
    By dvddvd in forum Classified Ads, Buy, Sell & Swap
    Replies: 1
    Last Post: 30-01-2022, 09:53 PM
  2. Tramming With Taut Wires
    By Kitwn in forum Gantry/Router Machines & Building
    Replies: 11
    Last Post: 26-07-2020, 01:52 AM
  3. Workbee with Duet 2 wifi and planet cnc
    By ravihotwok in forum Control Hardware & Systems
    Replies: 9
    Last Post: 20-06-2019, 08:26 AM
  4. Where to buy a tramming tool in the UK
    By Mad Professor in forum Tool & Tooling Technology
    Replies: 15
    Last Post: 08-02-2013, 12:10 PM
  5. Tramming round column MD30
    By irving2008 in forum Milling Machines, Builds & Conversions
    Replies: 6
    Last Post: 09-02-2009, 03:07 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •