Threaded View
-
22-09-2022 #1
Hi!
I'm new so I hope I did post this thread to the right category.
We have a very old CNC that hasn't been used in like 20 or more years and since I just graduated, I was tasked to retrofit it. Along with this is the Baruffaldi Tool Turret - TOE100. The thing is, I was told to control the turret using a PLC (FX3U clone to be exact). I refer to this manual: toe1001st.pdf. Firstly, I need to test out the positions of the tool turret.
The Encoder Code Table shows this:
I may be wrong but through very limited research (due to lack of information in the net), I wired the encoder to the PLC like this (NOTE 1: Supply Voltage = 24VDC) (NOTE 2: FX3U and the encoder are connected in parallel to a power source through DC+/DC-):
And programmed it like this:
The problem is, when I test it, it does nothing. The contacts do not close in accordance with the should-be position of the encoder. Can it be that the encoder is faulty? If my wiring is wrong, can you guys help me?
If you need more info, please don't hesitate to ask me.
Thank you so much!
Regards,
Jerico
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
110v 3 phase for baruffaldi turret
By jonnydeen in forum Motor Drivers & ControllersReplies: 17Last Post: 06-09-2020, 11:48 PM -
Baruffaldi RH80 turret
By Dangle_kt in forum Denford LathesReplies: 0Last Post: 14-03-2018, 03:35 PM -
Chester 626 turret mill
By Robin Hewitt in forum Machine DiscussionReplies: 2Last Post: 29-08-2017, 04:40 PM -
Denford Starturn Turret
By Leadhead in forum Lathes, Lathe Rebuilding & ConversionsReplies: 7Last Post: 11-09-2013, 08:36 AM -
CNC Turret Mill range
By newtoid1986 in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 28-11-2011, 07:23 PM
Bookmarks