Thread: question ...

  1. #1
    I read a thread not too long ago where a link to a Router build using epoxy between the frame joints was posted, for the life of me I cannot find it again. Anybody any ideas? (That will teach me to bookmark the snippits of info I want to re-read)
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

  2. there was a discussion in the thread 'opensource design' on this, but i dont recall a specific thread on the subject... there are some on CNCZone tho

  3. #3
    Hmmm, I remember that the link led to a site that belonged to an American guy, he built a huge steel framed machine and he used an epoxy type stuff between the joints and he also used it in combination with a surface table to put a flat layer on theframe members his linear rails were bolted to.
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

  4. There was this thread on CNCZone

  5. #5
    You are a Star ... that's the one ... I have marked it now, so I will not go asking daft questions again.

    Many Thanks
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

  6. #6
    There is this guy from the Uk
    http://www.cnczone.com/forums/showthread.php?t=30751

    Andy

  7. #7
    Yep got it ... thanks.
    Tim G-C

    I disapprove of what you say, but I will defend to the death your right to say it.

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

Similar Threads

  1. NEW MEMBER: Re my question
    By oldwoodworker in forum New Member Introductions
    Replies: 32
    Last Post: 20-09-2013, 09:07 PM
  2. PSU question
    By Dwayne Dibbley in forum General Electronics
    Replies: 16
    Last Post: 13-02-2013, 10:15 PM
  3. To usb,or not to usb,that is the question.
    By Jumbo in forum General Discussion
    Replies: 11
    Last Post: 17-10-2011, 09:21 PM
  4. Just a small question
    By Wobblybootie in forum Linear & Rotary Motion
    Replies: 4
    Last Post: 06-08-2010, 05:28 PM
  5. A question
    By bodgeitandscarper in forum Gantry/Router Machines & Building
    Replies: 7
    Last Post: 02-12-2009, 08:30 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •