. .
  1. #1
    OK I admit I am either blind or stupid (or both) ... where can I find this elusive Sheet? I am assuming its a spreadsheet ...:question:
    Tim G-C

    “I disapprove of what you say, but I will defend to the death your right to say it.”

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

  2. here in the tutorials section...

  3. #3
    Told you I was ..... Thanks Irving ...
    Tim G-C

    “I disapprove of what you say, but I will defend to the death your right to say it.”

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Holding down sheet material.
    By jcb121 in forum Machine Discussion
    Replies: 3
    Last Post: 03-07-2013, 12:11 AM
  2. How to cnc cut 1-2mm stainless sheet ??
    By Ricardoco in forum Metalwork Discussion
    Replies: 9
    Last Post: 28-03-2013, 04:06 AM
  3. THC lifting off sheet?
    By lockyg in forum Machine Discussion
    Replies: 2
    Last Post: 06-12-2012, 04:56 PM
  4. 3mm sheet brass
    By cropwell in forum Marketplace Discussion
    Replies: 1
    Last Post: 17-10-2012, 09:55 AM
  5. Had a go using motorcalc sheet but does not look right.
    By Bob_series1 in forum Stepper & Servo Motors
    Replies: 25
    Last Post: 16-01-2010, 11:17 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •