. .
  1. #1
    Hi all,

    Just found the CNCUK site, via a link from a local to Bournemouth CNC parts supplier via eBay etc. I've built a 3(+1) axis CNC mill based mostly on junk from scrap yards. Its a stepper based machine, driven via a Mesa 7i43 card etc, and is running EMC2 CNC controller software. A short write up of the machine is on the EMC2 website at http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Pjm

    I'm located in Poole, Dorset. Mostly the mill is used for light engineering jobs, making parts for microwave receivers etc. I learnt g-code, general machine practice etc from my father, who has worked on CNC's for years; The first machine I remember seeing had some punched tape reader for the program input, later it was Bridgeport MDI, Interact 1 &2, Fanuc Lathes, and Haas machine centres - I guess this is the stuff that got me hooked.

    regards,

    Paul.

  2. #2
    Nice set up, what dumpster dir you find the milling head!
    I'd like to look in that dumpster!

    Peter

  3. #3
    Nice job!! Hmmm we are almost neighbours I'm just west of Wareham ...
    Tim G-C

    “I disapprove of what you say, but I will defend to the death your right to say it.”

    (attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. BUILD LOG: Build and Intro
    By swisscheese in forum DIY Router Build Logs
    Replies: 51
    Last Post: 30-04-2014, 10:02 AM
  2. NEW MEMBER: Intro
    By vt356b in forum New Member Introductions
    Replies: 5
    Last Post: 02-09-2013, 11:39 AM
  3. NEW MEMBER: New here - new intro
    By ChrisTerry in forum New Member Introductions
    Replies: 3
    Last Post: 05-08-2012, 11:09 AM
  4. NEW MEMBER: Intro
    By Ian Hart in forum New Member Introductions
    Replies: 2
    Last Post: 22-02-2010, 06:06 AM
  5. NEW MEMBER: Intro...
    By Davidh in forum New Member Introductions
    Replies: 1
    Last Post: 29-08-2007, 01:58 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •