1. #1
    hi, ok ive made an rockcliff machine and have a slight problem the bed seem to be a little higher on the right hand side i was going to add another piece of mdf on top of the bed. But what i need piece g-code to level the bed, the bed is 340mm x 340mm ive tried but just cant get the gist of it ?

    hope someone can help me with the basics :?:

    i'm using Mach 3
    thanks for looking steve

  2. #2
    thanks very much kip i will give it ago this afternoon thanks again steve :)

  3. #3
    Did it work?
    .Me

  4. #4
    Any chance you could reup this to the post i think the change of forums has lost it. Wouldnt mind it formyself to.

  5. #5
    Thanks kip, i will move this to the FAQ section to.

Similar Threads

  1. NEW MEMBER: Hello! Another new guy wishing to pick brains and ask for opinions...
    By seashaw in forum New Member Introductions
    Replies: 4
    Last Post: 17-10-2013, 11:01 AM
  2. Can I pick your brains? How would you solve this puzzle....
    By HankMcSpank in forum General Discussion
    Replies: 45
    Last Post: 14-09-2011, 07:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •