. .
  1. #1
    plan request connection card PCPPS
    Hello all please is what you can help me make a connection of limit switch and emergency stop on the map PCPPS (at DIY CNC)

    thank you very much

  2. What control software are you using? E-stop normally uses the in5 pin and limit switches can be linked to the other inputs. depends on what control software you are using as to set up though most are similar.

    Michael

  3. #3
    Michael thank you for the reply
    MACH3 software as I please a quick sketch
    http://www.diycnc.co.uk/html/pcpps.html
    ali hedi

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. PCPPS B.O.B. - OK for spindle control?
    By birchy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 09-09-2013, 12:50 AM
  2. PCPPS V3 Power Supply?
    By birchy in forum General Electronics
    Replies: 4
    Last Post: 10-12-2012, 04:21 PM
  3. NEW MEMBER: Designer with a plan looking for advice
    By bigstu67 in forum New Member Introductions
    Replies: 2
    Last Post: 10-10-2012, 06:04 PM
  4. PCI parallel card / BOB
    By artmin in forum Computer Hardware
    Replies: 11
    Last Post: 30-01-2012, 04:38 PM
  5. So... what do you plan to do over the hols?
    By irving2008 in forum General Discussion
    Replies: 5
    Last Post: 23-12-2008, 09:03 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •