Belt drive and pulley sizes

[j2sip]

Thanks guys.

@ irving2008

It will be an all MDF machine. Do you think there will be deflection in that section? its only 200mm x 150mm square rom top to the V bearing line. But I'll put that in mind and incorporate a provision for some kind of reinforcement in that section.

@ John S

There will be support bearings at either sides of the big pulley and another 2 at the ends of the shaft. What I has me worried about is the Y lateral support (where the X motor's located). Do you think it will still provide rigidity as it is now divided into two to make room for the belt tot pass thru?

Again guys thank you very much.


JOrdan