Threaded View
-
25-07-2010 #1
I built my CNC Plasma Table about two years ago and it has really earned its keep in that time
It was originally built as a Wood Router, but all it ever made were Freebies for everyone else!
Because I run a small business making small Motorcycle parts, I decided to convert the machine over to Plasma.
The machines current cutting size is 985mm x 585mm and I want to increase the cutting size to accept a standard off the shelf sheet size.
I originally thought about increasing the table size to accept a 2000mm x 1000mm sheet, but now I think I can fit a 2500mm x 1250mm machine into the available space I have.
Here is a video of the Plasma machine working in its current state.
I use a Hypertherm Powermax 1000 which has a cutting capacity of 12.7mm maximum.
It also has a Torch Height controller (THC) that measures the Tip voltage and adjusts the Z axis to maintain the optimum cutting height.
The machine uses a water table to keep the dust down and also to keep the steel cool so it does not warp while cutting.
I plan on building a new water table for the new machine where I will be able to raise and lower the water level using compressed air
These are the Mods that I have in mind, this is the original machine
First I plan on removing the gantry and cutting the top off of the original table
I will then build a new frame to fit onto the existing table.
I want to build a lightweight gantry, the old machine has a heavy steel gantry that was designed for Wood Routing.
Because of this I have to keep the acceleration speeds right down which affects the cut quality on the corners.
When I cut 1.5mm Stainless Steel it cuts at 3810mm / Minute but if I used a 60A tip on thin material you need to almost double that speed :surprised:
Here I have used 25mm round supported rails for the X Axis and 15mm Hiwin Linear rails mounted onto a 30mm Aluminium Extrusion for the Gantry.
I would like to change the design of the gantry so I can use supported round rail because it is a lot cheaper than the Hiwin Rails, but not sure how I will mount these.......
I will be driving the Y axis using the existing tables X Ballscrew.
I am not sure how I will drive the x axis yet, I have a spare motor so I can have two motors driving.
I was thinking about using rack and pinion for the x axis but I am all ears to any other suggestions
That's it for starters now, all comments appreciated
Andy
Thread Information
Users Browsing this Thread
There are currently 12 users browsing this thread. (0 members and 12 guests)
Similar Threads
-
BUILD LOG: 4' x 4' plasma table build in Canada
By 190-v8 in forum DIY Plasma Build LogsReplies: 2Last Post: 02-02-2014, 01:19 AM -
10' x 5' Plasma table design
By Kerryfisher in forum Plasma Table MachinesReplies: 4Last Post: 20-02-2013, 09:28 AM -
RFQ: RFQ: Plasma Table
By D-man in forum Projects, Jobs & RequestsReplies: 3Last Post: 04-07-2010, 11:08 PM -
3M x 2M Plasma table build
By MonoNeuron in forum DIY Plasma Build LogsReplies: 14Last Post: 01-09-2009, 11:11 AM -
Plasma table 2m x 1m
By Robin Hewitt in forum DIY Plasma Build LogsReplies: 9Last Post: 19-05-2009, 12:48 PM
Bookmarks