Page 2 of 2 FirstFirst 12
  1. #11
    Hi Ze0paz.

    After the first debacle and your compelling point, am going to go right through all the wiring and give it a check and a tidy up..

    On a really cheap note (done this whole thing on the cheap), has anyone tried using pipe lagging (the foam tube type with a slit down the length,) as a cable tidy? Dead cheap, very light and flexible.. Gonna get a bit and try and try to set fire to it today, unless someone knows a compelling reason not to (excluding pyrophobics)...

    Steve..

  2. #12
    Steve

    Get down the pound shop or ikea and grab the stuff used for tidying up the tele cable clutter??????????? its a pound
    If the nagging gets really bad......Get a bigger shed:naughty:

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Help with 3 axis CNC motor and drives
    By domagoj55 in forum General Electronics
    Replies: 7
    Last Post: 04-03-2013, 12:51 PM
  2. THC lifting off sheet?
    By lockyg in forum Machine Discussion
    Replies: 2
    Last Post: 06-12-2012, 04:56 PM
  3. NEW MEMBER: Okuma Z axis motor
    By hidro in forum New Member Introductions
    Replies: 0
    Last Post: 21-03-2011, 02:15 PM
  4. NEW MEMBER: Okuma Z axis motor
    By hidro in forum New Member Introductions
    Replies: 0
    Last Post: 21-03-2011, 08:52 AM
  5. High Torque Motor Z Axis
    By Lee Roberts in forum Stepper & Servo Motors
    Replies: 5
    Last Post: 17-05-2009, 10:08 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •