Thread: Hot Foam cutter for RC aircraft
Hybrid View
-
12-08-2010 #1
Last Activity: 07-10-2010
Oh dear,don't want to dampen your expectations on that HongKong kit but I read somewhere about the driver boards are not up to scratch ie the chips pop at high peaks,it just miht of been a one off? but the uy who tested one seemed to know what he was doing.
I'll look for the source and you can judge for yourself,might of even been on here?.
http://www.mad-professor.co.uk/Misc/...AHQ%20Chip.jpg
This is not the site I'm lookin for but the info is the same ie popping chips.
http://www.cnczone.com/forums/archiv...p/t-93048.htmlLast edited by irving2008; 12-08-2010 at 08:37 AM. Reason: posts merged to reduce noise...
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Machineable foam
By craigrobbo in forum Marketplace DiscussionReplies: 7Last Post: 03-02-2013, 08:40 PM -
Machining Insulation foam
By Philly in forum Machine DiscussionReplies: 3Last Post: 28-01-2013, 12:38 AM -
CNC Hot Wire Foam Cutters
By HotwireCutter in forum Manufacturer NewsReplies: 0Last Post: 02-05-2012, 09:04 PM -
NEW MEMBER: First post - want to build a cnc hot wire foam cutter
By rckeith in forum New Member IntroductionsReplies: 8Last Post: 12-12-2010, 12:23 AM -
Software for foam cutter - any recommendations
By rckeith in forum Machine Control SoftwareReplies: 2Last Post: 08-08-2010, 10:14 AM
Bookmarks