. .
Page 2 of 2 FirstFirst 12
  1. #11
    Which bit?
    If the nagging gets really bad......Get a bigger shed:naughty:

  2. #12
    Quote Originally Posted by 2e0poz View Post
    Which bit?
    Your right, I am being very delusional!!
    The more I know, I know, I know the less. (John Owen)

  3. #13
    lol......:lmao:
    If the nagging gets really bad......Get a bigger shed:naughty:

  4. #14
    Is it just me or does anyone else think Lees hot ?

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson


  5. #15
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom. Last Activity: 20 Hours Ago Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 8-9 years. Has a total post count of 6,340. Received thanks 1,045 times, giving thanks to others 46 times.
    Quote Originally Posted by Fivetide View Post
    Is it just me or does anyone else think Lees hot ?
    What you smoking.!!!!!!

  6. #16
    Quote Originally Posted by JAZZCNC View Post
    What you smoking.!!!!!!

    Actually I'm vaping now , quit smoking the 40 a day death tabs 3 years ago at Christmas .. same time I quit drinking :) now I'm just an old boring bastard lol

    Fiction is far more plausible when wrapped around a thread of truth

    Nothing great was ever achieved without enthusiasm.
    Ralph Waldo Emerson


  7. #17
    now I'm just an old boring bastard lol
    Glad you joined the club
    ..Clive
    The more you know, The better you know, How little you know

  8. True, chip load is very important.

    Chip load refers to the size of the chips produced during cutting. The main purpose is to get the maximum chip load possible, so you can increase productivity, reduce heats bits during work, and also prevent premature dulling. The chip load is to small means bits will become too hot and dull quicker; chip load is too high means cutters will cause a bad surface finish, and in worse situation, the bits break.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Feed and speed equation
    By Bush Flyer in forum Spindles & Drive Motors
    Replies: 7
    Last Post: 18-03-2014, 01:32 AM
  2. stepper acceleration rate - limits?
    By dsc in forum Stepper & Servo Motors
    Replies: 11
    Last Post: 02-03-2014, 02:25 PM
  3. Pulse rate or dip switch settings
    By Jopo in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 29-04-2013, 08:08 AM
  4. Vc & feed/rpm of the these tools on steel
    By hoezap in forum Tool & Tooling Technology
    Replies: 2
    Last Post: 14-02-2013, 08:50 AM
  5. Router bit recommendation, spindle speed and feed rate?
    By FlightCaseCo in forum Spindles & Drive Motors
    Replies: 13
    Last Post: 03-04-2012, 12:53 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •