Page 2 of 2 FirstFirst 12
  1. #11
    hi gary....?been to your site(zap)is thesy85th118-4208 motors I see a price of +28 pounds is that correct?....bobin
    Last edited by bobin; 30-04-2009 at 07:30 PM. Reason: crap spelling

  2. It is a 28 adder.
    The way the site works, is you have a base price, and in this case it is 43.16 and then you add the adder dependant on the motor you choose.
    So in this case the price would be 71.42.

    Gary
    Quote Originally Posted by bobin View Post
    hi gary....?been to your sight(zap)is thesy85th118-4208 motors I see a price of +28 pounds is that correct?....bobin

  3. #13
    sorry for hogging your time but on the msd980 boards on direction you have a plus 5v and a minus?? what signals are needed for these....will the +5 and low single wire goto +5 ,,if so what goes to the neg-.....bobin

  4. Quote Originally Posted by bobin View Post
    sorry for hogging your time but on the msd980 boards on direction you have a plus 5v and a minus?? what signals are needed for these....will the +5 and low single wire goto +5 ,,if so what goes to the neg-.....bobin
    I have attached a wiring diagram, and i think this will help.
    Normally your direction signal goes to the Dir+ and the Dir- goes to ground.
    Attached Thumbnails Attached Thumbnails WIRING PM542&556.pdf  

  5. #15
    This might help a few people: Wiring Connection Diagrams | Lead Wire | Stepper Motors | Lin Engineering and this: http://reprap.org/wiki/Stepper_motor which goes a bit off the scope of wiring....

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Connection the plasma cutter to the CNC machine?
    By gr8fun in forum Plasma Table Machines
    Replies: 1
    Last Post: 22-05-2014, 10:49 AM
  2. Which Connection ?
    By manofgresley in forum Stepper & Servo Motors
    Replies: 16
    Last Post: 02-10-2013, 05:49 PM
  3. Or Guidance ;) Connection Name(s)
    By Carlb1058 in forum Marketplace Discussion
    Replies: 6
    Last Post: 13-07-2013, 12:48 AM
  4. ghost in the x axis - bad electrical connection
    By jonm in forum General Electronics
    Replies: 5
    Last Post: 11-04-2010, 08:31 PM
  5. plan request connection card PCPPS
    By ali hedi in forum General Electronics
    Replies: 2
    Last Post: 07-04-2010, 08:18 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •