. .
Page 2 of 2 FirstFirst 12
  1. #11
    hi gary....?been to your site(zap)is thesy85th118-4208 motors I see a price of +£28 pounds is that correct?....bobin
    Last edited by bobin; 30-04-2009 at 07:30 PM. Reason: crap spelling

  2. It is a £28 adder.
    The way the site works, is you have a base price, and in this case it is £43.16 and then you add the adder dependant on the motor you choose.
    So in this case the price would be £71.42.

    Gary
    Quote Originally Posted by bobin View Post
    hi gary....?been to your sight(zap)is thesy85th118-4208 motors I see a price of +£28 pounds is that correct?....bobin

  3. #13
    sorry for hogging your time but on the msd980 boards on direction you have a plus 5v and a minus?? what signals are needed for these....will the +5 and low single wire goto +5 ,,if so what goes to the neg-.....bobin

  4. Quote Originally Posted by bobin View Post
    sorry for hogging your time but on the msd980 boards on direction you have a plus 5v and a minus?? what signals are needed for these....will the +5 and low single wire goto +5 ,,if so what goes to the neg-.....bobin
    I have attached a wiring diagram, and i think this will help.
    Normally your direction signal goes to the Dir+ and the Dir- goes to ground.
    Attached Thumbnails Attached Thumbnails WIRING PM542&556.pdf  

  5. #15
    This might help a few people: Wiring Connection Diagrams | Lead Wire | Stepper Motors | Lin Engineering and this: http://reprap.org/wiki/Stepper_motor which goes a bit off the scope of wiring....

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. Which Connection ?
    By manofgresley in forum Stepper & Servo Motors
    Replies: 17
    Last Post: 13-07-2020, 01:55 PM
  2. Connection the plasma cutter to the CNC machine?
    By gr8fun in forum Plasma Table Machines
    Replies: 1
    Last Post: 22-05-2014, 10:49 AM
  3. Or Guidance ;) Connection Name(s)
    By Carlb1058 in forum Marketplace Discussion
    Replies: 6
    Last Post: 13-07-2013, 12:48 AM
  4. ghost in the x axis - bad electrical connection
    By jonm in forum General Electronics
    Replies: 5
    Last Post: 11-04-2010, 08:31 PM
  5. plan request connection card PCPPS
    By ali hedi in forum General Electronics
    Replies: 2
    Last Post: 07-04-2010, 08:18 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •