. .
  1. #1
    Ive come up against a problem with my build that im not sure of, here goes;
    the machine is basically a lathe to turn down the diameter of tyres, what I need help with is the z traverse. My plan was to have a lead screw with a manual handle, but my prototype proved it would be very uncomfortable to wind for so long, so I want to have a motor to drive it. The problem I have is that I need to be able to wind it on manually then switch to feed, the feed needs to be controllable incase the cut starts to have trouble. I also dont know what feed rate I need to begin with so I need to be able to vary it from nearly nothing. Any ideas? Is it possible to put a speed controller on the motor that drives the lead screw?

  2. #2
    Sounds like the best thing is a small DC motor driving a reduction gearbox with a variable speed on it.

    Something like this.

    Click image for larger version. 

Name:	positioner2.jpg 
Views:	1558 
Size:	109.7 KB 
ID:	2894

    This actually has two 15:1 gearboxes on itbecause i had them and I need this welding rotator to go from real slow to real slow plus a bit.

    It runs off a big mains variac and you wind it to whatever speed is comfortable.
    John S -

  3. #3
    Where can i get one of these variable speed controllers?

  4. #4
    Think I might have a spare one, PM me off list.
    John S -

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. BUILD LOG: New Build - For Your Amusement - MK-2 build
    By Karl in forum DIY Router Build Logs
    Replies: 12
    Last Post: 08-02-2017, 07:03 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts