1. #2
    Didn't sell at 495
    Problem is there are loads of these about and by the time you have thrown professional rigging at it you are on a looser to start.

    I used to buy Bridgeport Boss 's, easier machines to do as they were on steppers. the Hurco's are on high voltage analogue servo's and the drivers for these for step and direction output are very pricey. Last two Boss's I got, I got for free but by the time they had been collected, gutted and converted there was no profit in it.
    John S -

  2. May well be the case John if you're doing it for profit, but if I had the room I'd consider something like that or a Bridgeport. Point about servos is valid, tho I'd look to build a step/direction interface to the existing drivers if they were OK.

Similar Threads

  1. RFQ: Re my speaker project
    By oldwoodworker in forum Projects, Jobs & Requests
    Replies: 0
    Last Post: 10-05-2013, 11:14 PM
  2. NEW MEMBER: Where to find new job opportunity in Onsite machining
    By navinmg6585 in forum New Member Introductions
    Replies: 0
    Last Post: 09-05-2013, 12:54 PM
  3. Experienced CNC Milling and Turning Opportunity Lisburn N.Ireland
    By stevy123 in forum Opportunities Available & Sought
    Replies: 0
    Last Post: 19-12-2012, 10:14 AM
  4. RFQ: I need Help/Support with my project :)
    By gianluca_g in forum Projects, Jobs & Requests
    Replies: 16
    Last Post: 06-05-2012, 09:00 PM
  5. Homemade CNC Project Help
    By chaslam07 in forum Gantry/Router Machines & Building
    Replies: 1
    Last Post: 04-04-2012, 10:53 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts