. .
Page 2 of 2 FirstFirst 12
  1. #11
    mike's Avatar
    Lives in west midlands, United Kingdom. Last Activity: 09-01-2012 Has been a member for 9-10 years. Has a total post count of 10.
    thnk you!!

  2. #12
    Ignore the enable.
    Enable is only used when part of an advanced Estop system, more for production setups to conform to industrial H&S.
    John S -

  3. The Following User Says Thank You to John S For This Useful Post:


  4. #13
    mike's Avatar
    Lives in west midlands, United Kingdom. Last Activity: 09-01-2012 Has been a member for 9-10 years. Has a total post count of 10.
    thankyou jonh !!

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Driver wiring advice needed...
    By Wal in forum General Electronics
    Replies: 17
    Last Post: 09-06-2014, 06:11 PM
  2. Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  3. Stepper Driver / PSU / Breakout board Wiring ?
    By manofgresley in forum General Electronics
    Replies: 2
    Last Post: 16-08-2012, 05:41 PM
  4. Driver wiring to my computer for mach3 to control
    By AdCNC in forum Motor Drivers & Controllers
    Replies: 13
    Last Post: 01-04-2010, 12:27 AM
  5. wiring help
    By ste68blue in forum Stepper & Servo Motors
    Replies: 6
    Last Post: 29-07-2009, 10:23 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •