. .
  1. #1
    eltee's Avatar
    Location unknown. eltee Last Activity: Has a total post count of n/a. Referred 6117 members to the community.
    New to cnc - no experience - not bad with a lathe and just looking to see if I want to go down this route.
    Last edited by irving2008; 27-09-2010 at 01:04 PM.

  2. Hi eltee and welcome to the site. Lots of info here to help you decide... most will tell you that once you have CNC'd you wont want to go back, it opens up so many possibilities...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Hi from QLD Australia
    By Gus in forum New Member Introductions
    Replies: 2
    Last Post: 06-10-2011, 05:04 PM
  2. NEW MEMBER: Hi from Australia
    By packmansdaddy in forum New Member Introductions
    Replies: 0
    Last Post: 05-06-2011, 10:36 PM
  3. NEW MEMBER: G'day from Australia
    By packmansdaddy in forum New Member Introductions
    Replies: 1
    Last Post: 15-02-2011, 05:06 AM
  4. NEW MEMBER: Hi from Australia
    By halfa in forum New Member Introductions
    Replies: 1
    Last Post: 17-12-2010, 03:43 PM
  5. NEW MEMBER: Hi from Australia
    By amcc in forum New Member Introductions
    Replies: 1
    Last Post: 12-09-2010, 10:29 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •